Automatic BlueTooth connection detection?
-
- Posts: 1
- Joined: Tue Nov 03, 2020 5:04 pm
Automatic BlueTooth connection detection?
I use VoiceMeeter to keep control over my softphone at work, and it does a great job -- except that whenever I disconnect and reconnect my BlueTooth headset, I have to re-instruct VoiceMeeter to use the headset as Hardware Out. Is there any way to automate this?
-
- Posts: 1
- Joined: Thu Nov 12, 2020 7:10 am
Re: Automatic BlueTooth connection detection?
I'm also experience the same issue but with BT Headphones and other bluetooth speakers/mics.
Funny thing is that settings are saved, but when I reconnect devices no sound is passed through voicemeeter, unless I reselect device.
Is it possible maybe to use macro command to set/reselect output device at certain HW output (A1...A5)?
Regards,
K.
Funny thing is that settings are saved, but when I reconnect devices no sound is passed through voicemeeter, unless I reselect device.
Is it possible maybe to use macro command to set/reselect output device at certain HW output (A1...A5)?
Regards,
K.
-
- Site Admin
- Posts: 1434
- Joined: Sun Jan 17, 2010 12:01 pm
Re: Automatic BlueTooth connection detection?
restart audio engine is preferred.
Command.Restart = 1;
Command.Restart = 1;