Automatic BlueTooth connection detection?

The Virtual Audio Mixer discussions and support...
Post Reply
jonathanbrickman0000
Posts: 1
Joined: Tue Nov 03, 2020 5:04 pm

Automatic BlueTooth connection detection?

Post by jonathanbrickman0000 »

I use VoiceMeeter to keep control over my softphone at work, and it does a great job -- except that whenever I disconnect and reconnect my BlueTooth headset, I have to re-instruct VoiceMeeter to use the headset as Hardware Out. Is there any way to automate this?
KeiserSoze
Posts: 1
Joined: Thu Nov 12, 2020 7:10 am

Re: Automatic BlueTooth connection detection?

Post by KeiserSoze »

I'm also experience the same issue but with BT Headphones and other bluetooth speakers/mics.
Funny thing is that settings are saved, but when I reconnect devices no sound is passed through voicemeeter, unless I reselect device.

Is it possible maybe to use macro command to set/reselect output device at certain HW output (A1...A5)?

Regards,
K.
Vincent Burel
Site Admin
Posts: 1434
Joined: Sun Jan 17, 2010 12:01 pm

Re: Automatic BlueTooth connection detection?

Post by Vincent Burel »

restart audio engine is preferred.

Command.Restart = 1;
Post Reply