Supported VBAN Commands
Posted: Wed Jul 22, 2020 12:14 am
Hello Everyone,
Can I get some clarification on what commands are supported for VBAN when remote controlling another instance of Voicemeter?
I was trying to either issue a Global Hotkey command or a MacroButton command over VBAN to another instance of Voicemeter but it appears that I can only control the remote Voicemeter service. Does VBAN currently support the ability to issue KeyPress or Button(x).State on a remote system?
Here's an example of a command that I'm using:
SendText("vban1",Button(0).State=1;Strip(0).mute+=1;System.KeyPress("SHIFT+F1"))
Everything works perfectly for my local instance of Voicemeter when using the Macro Buttons, but I wanted to create a macro button that could remotely tell another instance of Voicemeter to either perform a keypress or a macro button press on the remote computer. The goal is to perform remote Key Presses on another computer while using a wireless tablet with Macrobuttons (like controlling OBS layouts with Global Hotkeys controlled by Voicemeter along with all the custom voicemeter strip/bus configurations in the same macrobutton).
Thank you in advance for your response!
Can I get some clarification on what commands are supported for VBAN when remote controlling another instance of Voicemeter?
I was trying to either issue a Global Hotkey command or a MacroButton command over VBAN to another instance of Voicemeter but it appears that I can only control the remote Voicemeter service. Does VBAN currently support the ability to issue KeyPress or Button(x).State on a remote system?
Here's an example of a command that I'm using:
SendText("vban1",Button(0).State=1;Strip(0).mute+=1;System.KeyPress("SHIFT+F1"))
- Strip(0).mute+=1 works perfectly by cycling the mute state of Strip(0) on the remote instance (confirming that SendText is working)
Button(0).State=1 does not press the macrobutton on the remote system, but it does show up on the VBAN Network Configuration as a received command
SystemKeyPress("SHIFT+F1") does not seem to perform the keypress on the remote system, but it does show up on the VBAN Network Configuration as a received command
Everything works perfectly for my local instance of Voicemeter when using the Macro Buttons, but I wanted to create a macro button that could remotely tell another instance of Voicemeter to either perform a keypress or a macro button press on the remote computer. The goal is to perform remote Key Presses on another computer while using a wireless tablet with Macrobuttons (like controlling OBS layouts with Global Hotkeys controlled by Voicemeter along with all the custom voicemeter strip/bus configurations in the same macrobutton).
Thank you in advance for your response!