Voicemeeter UMC Asio

[Tony EI7BMB]

Hi, I am using a behringer UMC404 HD with voicemeeter Banana. On start up the "Hardware UMC Asio" indicator flashes red, I have tried various settings without success however if I set the engine to "normal" in settings and then change back to "swift" it works and will continue working until next PC reboot. I'd appreciate any advice to resolve this

[Vincent Burel]

maybe the ASIO service is not ready when Voicemeeter is launched ... i don't know i've no this device... you may talk about this problem on Behringer online support / forum...

[Tony EI7BMB]

Thanks for reply Vincent. It is not a timing issue as I have waited many minutes before starting voicemeeter as a test.

[Vincent Burel]

ok, do you use the ASIO driver as output A1 ?
could you post a screenshot of the voicemeeter system settings dialog box (in voicemeeter menu)?

[Tony EI7BMB]

Hi, yes A1 was selected. I have ordered the smaller UMC204HD so i will try that when it arrives to see if it works any better and I will report back. Thanks again for your help

[cjunekim]

I have no problem using UMC404HD ASIO with voicemeeter banana. Have you updated the driver? They recently released an updated version. It is a major update.

[Tony EI7BMB]

Thanks I have a couple of drivers here to try when new unit arrives.

[Tony EI7BMB]

Just installed the UMC204HD with the latest driver from behringer site and the same error is occurring, heres a screenshot of my settings:

[Shark-2]

Did you try to set the ASIO Buffer to "Default"? Some ASIO Driver do only work with the Buffer size set in the Driver and not in an other application.

[Vincent Burel]

right, good remark, try with default ASIO buffer size (option in the Voicemeeter system settings dialog box).