ASIO output into Voicemeeter

The Virtual Audio Mixer discussions and support...
Posts: 6
Joined: Wed Aug 28, 2019 1:41 pm

ASIO output into Voicemeeter

Postby Alain » Thu Sep 05, 2019 9:54 am

Hi Vincent (and others),

I have the following situation in my PC:
- Creative Audigy ZS 2
- ASUS Essence stx II 7.1

I use the Digital-In of the Audigy to receive an AC3/DTS stream from an external device. The Creative drivers/card then decode that stream to 6 channels and sends it to its three analog outputs of the card (L+R, C+SUB, LS+RS).

In J-River I can 'listen' to the Creative ASIO and send those 6 channels through my Asus Soundcard without a problem.

But I would like to get that ASIO output through Voicemeeter. As far as I know, you can't attach ASIO/multichannel to the A1/2/3 inputs, so my question is (if possible):
How can I get an multi-channel ASIO output into Voicemeeter?



Vincent Burel
Site Admin
Posts: 1234
Joined: Sun Jan 17, 2010 12:01 pm

Re: ASIO output into Voicemeeter

Postby Vincent Burel » Fri Sep 06, 2019 8:28 am

ASIO Routing capabilities are explained in the user manual: ... Manual.pdf

voicemeeterBananaASIORouting.jpg (156.96 KiB) Viewed 1234 times

Posts: 6
Joined: Wed Aug 28, 2019 1:41 pm

Re: ASIO output into Voicemeeter

Postby Alain » Fri Sep 06, 2019 12:40 pm

Hi Vincent,

Thanks for that, I have seen that part but still doesn't get to me. Maybe I'm over thinking it:
I just would like to have 8 channels of ASIO:Creative to WDM:Dirac so Voicemeeter can do the volume.

If I select ASIO:Creative on the A1 bus, I can route the channels to A1/A2/A3 inputs or the A2/A3 bus like the manual says indeed. But from there how can I send it through my speakers (WDM: Dirac)?


Return to “Voicemeeter”

Who is online

Users browsing this forum: No registered users and 12 guests