Speaker levels are ignored

The Virtual Audio Mixer discussions and support...
Posts: 7
Joined: Tue Nov 15, 2016 11:47 am

Speaker levels are ignored

Postby mgutt » Thu Dec 15, 2016 9:49 pm


I'm using Voicemeeter to have audio on a multi-monitor setup on both monitor speakers. It works, but one monitor is louder than the other.

I tried to change the audio level through the playback device settings:

But Voicemeeter ignores them.

Is it planned to add audio level settings to the Voicemeeter system settings or is it possible to let Voicemeeter respect the playback settings?

I would donate 40 € if you add this feature to Voicemeeter (so I do not need to use Banana).

Vincent Burel
Site Admin
Posts: 1261
Joined: Sun Jan 17, 2010 12:01 pm

Re: Speaker levels are ignored

Postby Vincent Burel » Fri Dec 16, 2016 9:42 am

it's pending on device interface you select as output.
WDM/KS will try to open output device in Exclusive mode... bypassing Windows Mixer.

Voicemeeter is providing better gain control anyway.
you might use Voicemeeter Banana, providing 3 thrue independent physical BUS .
(while Voicemeeter Standard provide a single BUS to manage A1 and A2 output device).

Return to “Voicemeeter”

Who is online

Users browsing this forum: No registered users and 14 guests