VB-Audio's Information and Discussions
https://forum.vb-audio.com/
Carla, but since i'm not using it at the moment, may be I should just remove that?Vincent Burel wrote:ok, so it should work now,
i see you activated INSERT on physical strip #1
what application did you connect to Voicemeeter virtual insert ASIO driver ?
My set up is fairly simple - just a pair of Sennheiser HD 650 plugged into the ASUS STX II with native ASIO drivers installed.Andres wrote:If Latency is set to 10ms in the ASIO Control Panel and the sampling rate is 48kHz, the buffer size reported by Voicemeeter should be approximately 480 samples. I use a 10ms latency setting at 44.1kHz without any apparent problem.NightSovereign wrote:so I've switched everything to 48k hz to see if it's gonna make any difference. In this mode voicemeeter is not falling into crackling anymore at least, but all the other issues persist. When I go to the default buffering for asio it makes it 480, which, I would imagine is going to be even less stable, or do I miss something?
According to the Voicemeeter System Settings window you are patching ASIO input #1 to hardware input 1 and you are also using the virtual insert into hardware input 1. The hardware input 1 is not being routed to the A1 output so you shouldn't hear any level from this input in your headphones. Maybe you could describe a little further your setup in that respect.
if you application (carla) is connected and does nothing (no signal transport) while you have activated the insert return... you may get nothing in your hardware input #1... or you shutdown Carla, or you disable the insert patch in voicemeeter system settings dialog box.NightSovereign wrote:Carla, but since i'm not using it at the moment, may be I should just remove that?Vincent Burel wrote:ok, so it should work now,
i see you activated INSERT on physical strip #1
what application did you connect to Voicemeeter virtual insert ASIO driver ?
And all of that is not changing anything for my initial problem.Vincent Burel wrote:if you application (carla) is connected and does nothing (no signal transport) while you have activated the insert return... you may get nothing in your hardware input #1... or you shutdown Carla, or you disable the insert patch in voicemeeter system settings dialog box.NightSovereign wrote:Carla, but since i'm not using it at the moment, may be I should just remove that?Vincent Burel wrote:ok, so it should work now,
i see you activated INSERT on physical strip #1
what application did you connect to Voicemeeter virtual insert ASIO driver ?
Vincent Burel wrote:if the sound is still choppy with your ASIO driver, simply change it for WDM interface.