Channel routing

[Alain]

Hi,

Following situation:

Voicemeeter Banana
- Input A1 - WDM USB sound card 1 Line In
- Input A2 - WDM USB sound card 2 Line In
- Input A3 - WDM USB sound card 3 Line In
- Output A1 - WDM Asus sound card

What I would like to do is:
- Input A1 -> Left+Right of Output A1
- Input A2 -> Center+LFE of Output A1
- Input A3 -> Left+Right Surround of Output A1

I know this is possible to do with the Composite Patch, but then I cannot control the volume anymore. I currently can do this with a vst host (Element LT), but it adds another layer (delay) to the audio chain.

Is this possible to do directly within Voicemeeter?

Regards,
Alain

[Vincent Burel]

well, this is not possible to re-route voicemeeter output BUS in voicemeeter input.
what is the workflow requiring this ?

[Alain]

I would like to run Apple TV HDMI audio output through PC for volume control (Voicemeeter), bass rerouting (Equalizer APO) and room correction (Dirac).

Current workflow:

Apple TV HDMI -> HDMI 5.1 LPCM Audio extractor
HDMI 5.1 LPCM Audio extractor Left + Right RCA -> USB soundcard 1 Line In
HDMI 5.1 LPCM Audio extractor Cen + LFE RCA -> USB soundcard 2 Line In
HDMI 5.1 LPCM Audio extractor LS + RS RCA -> USB soundcard 3 Line In

Voicemeeter Banana
- Input A1 - USB sound card 1 Line In
- Input A2 - USB sound card 2 Line In
- Input A3 - USB sound card 3 Line In
- Patch insert A1, A2 and A3 through Element LT (vst host)
- A1 -> A4 Left + Right
- A2 -> A4 Cen + LFE
- A3 -> A4 LS + RS
- Output A1 (Equalizer APO attached) -> ASUS soundcard -> amplifier -> 5 speakers

So it would be nice if Voicemeeter could do the 'Element LT part', as it gives less of a delay I assume. But if it is not possible I'm happy with the current setup and/or invest in the future for a >6 channel input sound card (Focusrite/Behringer/Tascam etc).